CHANCE TO WIN PRIZE FOR MY SUBSCRIBERS FROM 22/02/2019 TO 05/03/2019 (DATE EXTENDED)

Hello All!!
We are very thankful to our channel subscribers and regular visitors of our website. We, therefore, want to reward our fans and subscribers. So,here comes the chance to win exciting prize. We announce the CHANCE TO WIN PRIZE FOR MY SUBSCRIBERS . To participate in the quiz:
1.The contests starts from 22/02/2019 and ends on 05/03/2019 at midnight. The winners will be declared on 07/03/2019 on our You tube channel and website.

2. The person should be a citizen of India and above 15 years old of age.

3. The person should be a subscriber of our Youtube channel else he will be disqualified. So,If you are not a subscriber, visit our you tube channel: and press “SUBSCRIBE” button to subscribe our channel. The proof of subscribing the channel will be required at a later stage.

4. The Quiz will have 1 winner ONLY

5. If there are more than one participants for the prize, then winner among them will be decided by lucky draw.

6. The prize of the WINNER is  SHOPO POLISHED WOODEN PEN STAND BIG SIZE WITH DRAWER, MOBILE HOLDER AND REMOTE STAND FOR OFFICE DESK, TABLE ACCESSORIES ALL IN ONE MULTIPURPOSE DESK ORGANIZER.

                                         

                                               

 

Click the link below to watch the video :-

https://youtu.be/N1DAS3cowEU

The quiz question is :-

  1. Large than 15 degree side cutting edge angle _________________________.

(a) Increase tool life.

(b) Decrease tool life.

(c) Produce chipping and decreases tool life.

(d) Results in excessive stress concentration and greater heat generation.

Write your answer with your name and Email ID in the comment box below :-

 

Related posts

2 Thoughts to “CHANCE TO WIN PRIZE FOR MY SUBSCRIBERS FROM 22/02/2019 TO 05/03/2019 (DATE EXTENDED)”

  1. Shivam Dingane

    Answer :- “C”

    If we decrease the cutting edge angle, tool strength increases & heat generates due to slightly increasing the contact between tool and component, hence option D is eliminated, as strength decreases tool life will never increase hence option A gets eliminated, and due to large cutting edge angle chipping will produce so only tool life decreases D is not so suitable, hence my answer is “C”

  2. Sunny

    Answer is option “C”

Leave a Comment